![]() If you are getting the most out of parameters in Inventor, there will be occasions when you will need to see more than just the value of a dimension. This option will display the components that are related to a constraint! You can also right click on a constraint and select “Other half”…but I like the extra information I see with this option.Īccess: TOOLS (tab) – OPTIONS (panel) - APPLICATION OPTIONS (command) – ASSEMBLY (tab)īy default Inventor displays the value only for dimensions. Look how big the dimensions and the UCS are when the scale is set to 5!! It makes me feel like I am using binoculars!Īccess: TOOLS (tab) – OPTIONS (panel) - APPLICATION OPTIONS (command) – GENERAL (tab) – Annotation ScaleĦ – Component Names After Relationship Names ![]() The default value is 1, but the scale can be set from 0.2 to 5.0. This sets the size of dimension text, arrowheads and other symbols. If not, you may want to use a larger Annotation Scale in Inventor. Hopefully your vision is better than mine. I am not getting any younger so my eyes deteriorate just a little every day. (An exception might by something like a screw or bolt.) If you turn this option on, you will see green arrows indicating the degrees of freedom for a component.Īccess: In an ASSEMBLY - VIEW (tab) – VISIBILITY (panel) – DEGREES OF FREEDOM Similar to the previous tip, you should (almost) always full constrain your assemblies. Click again to hide the degrees of freedom.Īccess: In a SKETCH – click on the icon in the STATUS BARĤ- Display Degrees of Freedom (Assemblies) The lines are dimensioned, but they are still “floating” in the X and Y direction. In my screenshot, you can see the red arrows indicating the degrees of freedom in my sketch. If you are ever in this situation, go into the sketch and you can toggle your degrees of freedom by clicking on the icon in the status bar. ![]() But in more complicated sketches, it’s hard to find which dimensions or constraints you need to constrain your geometry. These tell me the depth of my extrusion and the size of my fillet.Īccess: TOOLS (tab) – OPTIONS (panel) - APPLICATION OPTIONS (command) – PART (tab)Ī good practice is to always fully constrain your sketches. This option will show you extra detail about the feature you wouldn’t normally see in the Inventor browser! In my screenshot below, you can see “(New Solid x 1in)” and “(0.125in)”. The second option is to right click on a command and then select “Add to Quick Access Toolbar” from the menu. I recommend at least adding “iProperties”. The first is clicking on the pull down menu then selecting the command. (You can move the QAT to below the ribbon also.) You have two options for adding commands to the QAT. The QAT is the toolbar that is by default located at the top of your application window, above your ribbon. The QAT is now in every windows application, so you can use this tip for all of them. In no particular order, here are my 9 Inventor tips you should start using immediately: 1- Quick Access Toolbar (QAT)Īdd your frequently used commands to the Quick Access Toolbar. Most of the tips listed here are ones that you can just “turn on”, put in your template, or setup once and forget about them. But there were just as many, if not more, that I knew I really wasn’t going to use. As you can imagine there were lots of results. I recently did a search for “Autodesk Inventor Tips”.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |